EBKA SoftHeat Thermostat
INSTALLATION INSTRUCTIONS
FOR EBHA SOFTHEAT BASEBOARD
Description
The EBKA-1-24 end cap thermostat kit is an accessory
for the EBHA Series of hydronic baseboard heaters.
This kit will provide thermostatic control of the heater
in place of a wall mounted thermostat.
Note: The EBKA-1-24 end cap thermostat can only
be installed on the left end of heater. It is designed
e
to control only one EBHA heater unit.
Tools Required: Phillips Screwdriver, Insulated Wire
®
Connectors (Wire Nuts ), Strain relief connector
FIGURE 1: Thermostat kit assembly
EBKA
Thermostat
EBHA Heater
Junction box cover
IMPORTANT INSTRUCTIONS
If you are uncomfortable working with electrical appliances, unable to follow these guidelines,
or do not have the necessary equipment; consult a licensed electrician.
WARNING
Turn the electrical power off at the electrical panel board (circuit breaker or fuse box) and lock
or tag the panel board door to prevent someone from turning on power while you are working on
the heater. Failure to do so could result in serious electrical shock, burns, or possible death.
SAVE THESE INSTRUCTIONS
TEL: 360-693-2505 Fax: 360-694-8668 P.O. Box 1675 Vancouver, WA 98668-1675
|